Jumper Set:

  • H: Repeat Trigger In this mode, the motion detector will send a high signal whenever motion is detected, and it will reset after the time delay.
  • L: Single Trigger In this mode they motion detector will provide a high output signal when motion is detected, but will remain on until the device is reinitialized.


  • Sensitivity Adjust Adjust this to change how far away the device will sense motion
  • Time Delay Adjust Adjust how long should the sensor wait between reset between 300 and 5 seconds.

Note that this device takes approximately one minute to initialize after applying power.

Be sure to select the wiringPi pin you are selecting when adding this device.